Sharp MX-M1054 - Page 19

MX-M1204 MX-M904/M1054/M1204 (MAIN UNIT) 2 – 18
O. Necessary procedures before moving the
machine
1) If the following options are installed, remove all of them from
the machine.
• Large capacity tray
• Inserter
• Finisher
• High capacity stacker
• Curl correction unit
• Relay unit
• Paper feed system option
2) Remove the following consumable parts from the machine.
• Paper
• Toner cartridge
• Development cartridge
3) Lock the following sections.
• Scanner (Optical section)
• Paper cassette lift plate
4) Attach the protection material to the position shown below.
• Use the "packing material for fixing the separation pawls"
which was removed when unpacking.
NOTE: Since the hard disk drive is built in the machine, refrain
from vibrations or shocks to the machine when in transit.