Sharp MX-M365N - Page 14

MAINTENANCE
SHARP
14
SHARP Document Solution Centre
Maintenance Indications:
DK
Black Drum (Counter) has reached
the specified life.
Replace Black Drum
Process
Section
(Drum)
VK
Black Developer (Counter) has reached
the specified life.
Replace Black Developer.
Process
Section
(Developer)
FK1
Fusing Roller Print Counter has reached the
specified limit.
Replace the Fusing
Upper Heat Roller Kit.
Fuser
Section
FK2
Fuser Pressure Roller Print Counter has
reached the specified limit.
Replace the Pressure
Roller Kit.
FK3
Fuser Web Cleaner (Counter) has reached
the specified limit
(Pop Up FK3 Error – Web End Detected)
Replace the
Web Cleaning Kit
MC
Main Charger Unit Counter has reached the
specified limit.
Replace Main Charger Kit
Process
Section
TK1
Transfer Unit Counter has reached the
specified limit.
Replace Transfer Unit
Transfer
Section
TA
Maintenance [All] Counter has reached specified limit
Starting Powder:
The following starting powder should be applied to the relevant consumable item during maintenance:-
Starting Powder
OPC Drum
MX-M365N
MX-M465N
MX-M565N
Apply CKOG-0345DS51 [Yellow Toner] on top of
UKOG-0312FCZZ [Stearic Acid]
CKOG-0345DS51 Yellow toner