SHARP Document Solution Centre
Measures to prevent breakage of spring pin in the fusing gear joint shaft
unit due to the load in the pressure roller section.
Measures to improve the MC cleaning performance.
Measures to prevent noise caused by the transport follower roller.
Improvement to prevent noise from the paper feed reverse roller within
the paper feed unit.
Measures against PDPPD1_N paper jam caused by the deteriorated
cushion.
Setup of new service parts - Saddle stapler
Enhancement of MF rotation pawl spring
Staple Unit & Staple Cartridge listing
Open SSL vulnerability - Firmware release for field support
Rom version upgrade (including revision history)
Change in colour of the Photoconductor Drum
Sharp Remote Device Manager [SRDM] v1.4
New part registration - Paper feed drive sub unit.
Measures to prevent F1-00 error code caused by the contact failure of
the paper surface detection sensor.
Measures against H3-00 error code caused by the electrostatic
discharge.
Elimination of two springs to improve productivity.
Measures to prevent streaks in the paper path direction when printing
solid black and colour images.
Modification of Control PWB
Amendment note when replacing the OPC Drum
Firmware update to support MXM365N/465N/565N series
Firmware version upgrade and change of transport motor to support
MXM365M/465N/565N series
Registry growth when using an auto created printer under a Citrix or
terminal services environment.
Enhancement to prevent damage to the flag paper detect up (F1-15)
Enhancement of gear strength in the SD drive section
To Next Page
Loading...
