Disabling of Slave Machine Mode
To prohibit tandem reception, enable this setting. (Normally this setting is not necessary.)
Auto Switching of Finisher Trays
If the number of sheets on the upper finisher tray reaches the sheet limit, output will
automatically switch to the lower tray.
Optimization of Hard Disk
Various devices mounted on the machine can be set.
This function optimizes the hard drive of the machine by defragmenting data. If a job is in
progress, a message will appear and optimization will not begin until the job is finished.
During optimization, the following operations are not possible:
Access to Setting mode (Web version), and reception of print data
Use of keys on the operation panel
Turning off the power with the main power switch of the machine.
Auto Power Shut-Off
When optimization is completed, the machine will automatically restart.
Fusing Cleaning Mode
To use the tandem function when user authentication is enabled, the same login name and
password must be used on both the master machine and slave machine. If the same login
name and password are not used, the page count may not be added to the appropriate user
count or only the master machine may print.
The factory default setting for the port number is [50001]. Unless you experience difficulty
with this setting, do not change the port number.
When the document filing function is frequently used and output of files seems somewhat
slow, optimizing the hard drive may improve performance.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1094 of 1441 3/17/2016 7:14 AM