Use this function to clean the machine's fusing unit when dots or other dirt appear on the
printed side of the paper. When this function is executed, "V" printed paper is output and
the fusing unit is cleaned.
Fusing Control Settings
These are used to control the toner fusing temperature according to the weight of the
paper.
These settings apply to plain paper, recycled paper, punched paper, pre-printed paper,
letterhead paper, colored paper, and user type paper.
You can select "16 to 23 lbs." or "23+ to 28 lbs." ("60g/m
2
to 89g/m
2
" or "90g/m
2
to
105g/m
2
").
List Print
To specify [One Sided] or [Two Sided] printing in List Print.
Black Streak Reduction
Specify to use the black streak reduction or not.
The black streak reduction can be used for Scan Original, Copy, Image Send, and Scan to
HDD functions.
If the black streak reduction is enabled, select any of the following options.
Process Black Thin Streaks
If improvement is not noticed after the first time you use the function, try executing the
function again.
Be sure to use only paper that is in the same weight range as the weight range set
here. Do not mix plain or other paper that is outside the range with the paper in the
tray.
When settings are changed, the changes will take effect after the machine is
restarted. To restart the machine, see "TURNING ON THE POWER" in "BEFORE
USING THE MACHINE"
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1095 of 1441 3/17/2016 7:14 AM