EasyManua.ls Logo

Sharp MX-M365N - Page 1159

Sharp MX-M365N
1441 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PROTOCOL SETTINGS
Select the general network settings.
The TCP/IP, NetWare, EtherTalk, and NetBIOS status information can be set.
TCP/IP
TCP/IP Settings
TCP/IP
To use the machine on a TCP/IP network, this setting must be enabled.
IPv4 Settings
When using the machine on a TCP/IP (IPv4) network, use this setting to configure the IP
address of the machine.
DHCP/BOOTP
Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host
Configuration Protocol)/BOOTP (Bootstrap Protocol). When this setting is enabled, it is
not necessary to manually enter an IP address.
RARP
Set this option to use the RARP protocol.
IPv4 Address
Enter the IP address of the machine.
Subnet Mask
Enter the IP subnet mask.
If DHCP/BOOTP is used, the IP address assigned to the machine may change automatically.
If the IP address changes, printing will not be possible.
If the machine is used on a TCP/IP network, be sure to enable the "Enable TCP/IP" below.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1159 of 1441 3/17/2016 7:14 AM