Default Gateway
Enter the default gateway address.
IPv6 Settings
When using the machine on a TCP/IP (IPv6) network, use this setting to configure the IP
address of the machine.
IPv6
Enable this setting.
DHCPv6
Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host
Configuration Protocol) v6. When this setting is enabled, it is not necessary to manually
enter an IP address.
Manual Address/Prefix Length
Enter the IP address and the prefix length (0 to 128) of the machine.
Default Gateway
Default Gateway
Ping Command
Checks if the machine can communicate with the PC of the network.
Specify the IP address of the desired PC and tap the [Execute] key. A message indicating
a response by the PC or not is displayed.
NetWare
If DHCPv6 is used, the IP address assigned to the machine may change
automatically. If the IP address changes, printing will not be possible.
If the machine is used on a TCP/IP network, be sure to enable the "Enable
TCP/IP" below.
In an IPv6 environment, the machine can use LPD or IPP protocol.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1160 of 1441 3/17/2016 7:14 AM