IMAGE ROTATION DOES NOT TAKE PLACE
If you are unable to solve a problem using the solutions in this manual, press the [Power]
button and then turn the main power switch to the " "position. Wait at least 10 seconds
and then turn the main power switch to the " "position. After the main power indicator
color changes to green, press the [POWER] button.
Point to check Solution
Did you select the copy
ratio manually?
Copy using automatic ratio selection.
Are you copying using s
ettings that do not allow
rotate copying?
Rotate copying can generally be combined with other modes as required,
however, some combinations are not possible. If a prohibited combination i
s selected, a message will appear in the touch panel.
Is "Rotation Copy Setti
ng" disabled in the setti
ng mode?
Check with your administrator.
If you are the administrator, enable [Rotation Copy Setting].
Select [System Settings] → [Copy Settings] → [Rotation Copy Setting]
→ [Rotation Copy] in "Setting mode".
When the background color of the job status display at the upper right corner of the touch
panel is not gray, do not switch off the main power switch or unplug the power plug. This may
damage the hard drive or cause the data being stored or received to be lost.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1262 of 1441 3/17/2016 7:14 AM