2-SIDED COPYING DOES NOT TAKE PLACE
If you are unable to solve a problem using the solutions in this manual, press the [Power]
button and then turn the main power switch to the " "position. Wait at least 10 seconds
and then turn the main power switch to the " "position. After the main power indicator
color changes to green, press the [POWER] button.
Point to check Solution
Does the paper type setting of the
selected tray specify a type of pape
r that cannot be used for 2-sided c
opying?
Check "Tray Settings" in the setting mode.
If the [Disable Duplex] checkbox is selected, 2-sided copying
using that tray will not be possible. Change the paper type sett
ing to a type that can be used for 2-sided printing.
Set [System Settings] → [Paper Tray Settings] → [Tray Setti
ngs] → [Disable Duplex] to in "Setting mode".
Are you using a special size or type
of paper?
For the paper types and sizes that can be used for two-sided
copying, see "SPECIFICATIONS" in Quick Start Guide.
Are you copying using settings that
do not allow 2-sided copying?
2-Sided Copy can generally be combined with other modes as
required, however, some combinations are not possible. If a pro
hibited combination is selected, a message will appear in the to
uch panel.
Have functions been disabled by th
e administrator?
Some functions may have been disabled in the setting mode. C
heck with your administrator.
When user authentication is enabled, the functions that you c
an use may be restricted in your user settings. Check with yo
ur administrator.
When the background color of the job status display at the upper right corner of the touch
panel is not gray, do not switch off the main power switch or unplug the power plug. This may
damage the hard drive or cause the data being stored or received to be lost.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1263 of 1441 3/17/2016 7:14 AM