PART OF THE IMAGE IS CUT OFF
If you are unable to solve a problem using the solutions in this manual, press the [Power]
button and then turn the main power switch to the " "position. Wait at least 10 seconds
and then turn the main power switch to the " "position. After the main power indicator
color changes to green, press the [POWER] button.
Point to check Solution
Does the paper size specified by the job matc
h the size of paper loaded into the tray?
Make sure that the paper size setting matches
the size of paper loaded into the tray.
Windows: The setting is selected in the [Paper Sele
ct] tab of the printer driver.
If [Fit To Paper Size] is selected, check the loaded p
aper and the paper size setting.
Macintosh: The setting is selected in the [Page Set
up] menu.
Is the print orientation setting (portrait or land
scape) correct?
Set the print orientation to match the image.
Windows: The setting is selected in the [Main] tab of
the printer driver.
Macintosh: The setting is selected in the [Page Set
up] menu.
Are the margins set correctly in the layout se
ttings of the application?
Select an appropriate paper size and margins in
the layout settings of the application.
If the edge of the image extends outside the printabl
e area of the machine, the edge will be cut off.
When the background color of the job status display at the upper right corner of the touch
panel is not gray, do not switch off the main power switch or unplug the power plug. This may
damage the hard drive or cause the data being stored or received to be lost.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1278 of 1441 3/17/2016 7:14 AM