EasyManua.ls Logo

Sharp MX-M365N - Page 1281

Sharp MX-M365N
1441 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TRANSMISSION DOES NOT TAKE PLACE
If you are unable to solve a problem using the solutions in this manual, press the [Power]
button and then turn the main power switch to the " "position. Wait at least 10 seconds
and then turn the main power switch to the " "position. After the main power indicator
color changes to green, press the [POWER] button.
Point to check Solution
Is the telephone line connected
securely?
Check the telephone line jack, the wall jack, and any exten
sion adapters to make sure that all connections are secur
e.
- SIDE AND BACK
Is the correct dial mode set for
your line?
Ask your administrator to verify that "Dial Mode Setting" i
s set correctly for the line you are using.
Select the telephone line type in "Dial Mode Setting" in the setti
ng mode (administrator).
"Setting mode" → [System Settings] → [Image Send Settings]
→ [Fax Settings] → [Default Settings] → [Dial Mode Setting]
Is a busy signal received? If a busy signal is received, the transmission is temporarily cancel
ed and then automatically attempted again after a brief interval. (F
actory default setting: 2 attempts, 3 min. intervals)
"Setting mode" → [System Settings] → [Image Send Settings]
→ [Fax Settings] → [Send Settings] → [Recall in Case of Line B
usy].
To cancel the transmission, tap the job status display on the oper
ation panel, tap the key of the print job that you wish to delete, a
nd tap the [Stop/Delete] key. A message will appear to confirm t
he cancelation. Tap the [Cancel] key.
Did a communication error occu
r?
If an error occurs that prevents transmission, the transmission is
temporarily canceled and then automatically re-attempted after a
brief interval. (Factory default setting: 2 attempts, 3 min. intervals)
When the background color of the job status display at the upper right corner of the touch
panel is not gray, do not switch off the main power switch or unplug the power plug. This may
damage the hard drive or cause the data being stored or received to be lost.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1281 of 1441 3/17/2016 7:14 AM