TRANSMISSION TAKES A LONG TIME
If you are unable to solve a problem using the solutions in this manual, press the [Power]
button and then turn the main power switch to the " "position. Wait at least 10 seconds
and then turn the main power switch to the " "position. After the main power indicator
color changes to green, press the [POWER] button.
Point to
check
Solution
Is the res
olution se
tting appr
opriate at
the time
of scanni
ng?
Select resolution and data compression settings that are suited to the purpose
of transmission.
To create image data that is balanced in terms of resolution and file size, pay attention t
o the following points:
Resolution settings
The default resolution setting is [200x200dpi] in "E-mail", "FTP/Desktop", "Network F
older", and "Scan to External Memory Device", and [200x100dpi] in Internet fax mode. If
the original does not contain a halftone image such as a photo or illustration, scanning at
the default resolution will create a more practical and useful image. A higher resolution s
etting or the "Half Tone" setting (in Internet fax mode only) should only be selected if th
e original contains a photo and you wish to give priority to the quality of the photo image.
Exercise caution in this case as a larger file will be created than when the default setting
is used.
When the background color of the job status display at the upper right corner of the touch
panel is not gray, do not switch off the main power switch or unplug the power plug. This may
damage the hard drive or cause the data being stored or received to be lost.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1305 of 1441 3/17/2016 7:14 AM