A DESTINATION IS PRE-SELECTED
If you are unable to solve a problem using the solutions in this manual, press the [Power]
button and then turn the main power switch to the " "position. Wait at least 10 seconds
and then turn the main power switch to the " "position. After the main power indicator
color changes to green, press the [POWER] button.
Point to check Solution
Is [Default Address Setting]
enabled in the setting mode
?
If you wish to send to a destination other than the default dest
ination, tap the [Cancel] key.
If you are the administrator and wish to change or disable the default
destination, change the settings as appropriate in [Default Address Se
tting].
"Setting mode" → [System Settings] → [Image Send Settings] → [S
can Settings] → [Default Address] → [Default Address Setting]
When the background color of the job status display at the upper right corner of the touch
panel is not gray, do not switch off the main power switch or unplug the power plug. This may
damage the hard drive or cause the data being stored or received to be lost.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1306 of 1441 3/17/2016 7:14 AM