EasyManua.ls Logo

Sharp MX-M365N - Page 1328

Sharp MX-M365N
1441 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PRINTING IS NOT POSSIBLE OR STOPS
DURING A JOB
Point to check Solution
Is a tray out of paper? Add paper as instructed by the message in the to
uch panel.
Is the machine out of toner? Replace the toner cartridge.
When toner runs low, a message will appear to inform y
ou that the toner cartridge must be replaced.
For more information on replacing the toner cartridge,
see "REPLACING THE TONER CARTRIDGE".
Has a paper misfeed occurred? Remove the misfeed as instructed by the messag
e in the touch panel.
- "REMOVING MISFEEDS" in "TROUBLESHOOTING"
Is the output tray full? Remove the output from the tray and resume prin
ting.
When the output tray becomes full, a detector activate
s and stops printing.
Is the toner collection container full? Replace the toner collection container as instruc
ted by the message in the touch panel.
- "REPLACING THE TONER COLLECTION CONTAINE
R"
Are restrictions placed on the trays that ca
n be used in each mode (copy, print, fax, Int
ernet fax, and document filing)?
Check the settings in [Paper Tray Settings] and
see if checkmarks appear in the checkboxes of e
ach mode ([Feeding Approved Job]).
Functions without a checkmark cannot be used for pri
nting using that tray.
"Setting mode" → [Paper Tray Settings] → [Tray Reg
istration] → [Feeding Approved Job]
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
1328 of 1441 3/17/2016 7:14 AM