USING A BILLING CODE
Overview
If the use of billing code is enabled in "Setting Mode (Administrator", the billing code entry window is
displayed at the time of mode transition (at the time of printing/sending in document filing mode).
Enter the main code or sub code as required.
Specifying a billing code again
To change the specified billing code to another one, tap the [Switch Billing Code.] key on the action
panel.
When the billing code entry window is displayed, select a new billing code.
Operation
Select a billing code from the list
Select the desired billing code from the list of registered billing codes.
You need to register billing codes in advance.
REGISTERING A NEW BILLING CODE
To enable the billing code
Select "Setting Mode (Administrator)" - [Billing Code Setting] - [Administration Settings], then
set [Use Billing Code] to [Enable].
To retain the specified billing code at the time of mode transition
Select "Setting Mode (Administrator)" - [Billing Code Setting] - [Administration Settings], then
set the [Take Over Billing Code at Mode Transition] check box to . This eliminates the need
to enter billing codes at each mode transition.
You can assign billing codes to reprinting/resending of target files and sending of print jobs from
"Setting Mode (Web version)" - [Document Operations].
When the billing code entry window is displayed, tap the [Select from List] key of the
main code.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
164 of 1441 3/17/2016 7:14 AM
To Next Page
Loading...
