CARD SOLUTION KIT
This section explains the settings and login procedure for CAC authentication using the
MX-EC50 (Card Solution Kit), and the functions that can be accessed used when using
CAC authentication.
SETTING PROCEDURE
LOGIN PROCEDURE WHEN USING CAC AUTHENTICATION
MACHINE FUNCTIONS WHEN CAC AUTHENTICATION IS USED
SETTING PROCEDURE
To perform authentication using a CAC card, the settings must first be configured in the
Web page. (Administrator rights are required.) Configure the settings as explained below.
User Control Settings
The settings can also be configured in System Settings on the operation panel.
(Administrator rights are required.)
If you need to enter to the System Settings (Administrator) on the operation panel, follow
these steps:
Login to the machine as an administrator to change System Settings on the
operation panel when the Card reader is connected.
In addition to login by tapping the [Admin Login] key, the system settings
(administrator) can also be accessed when login is performed by selecting a user
with administrator rights from the user list or by entering a user number with
administrator rights. For more information on login procedures when user
authentication is enabled, see "USER AUTHENTICATION".
If login will be performed using the CAC card reader, read "LOGIN PROCEDURE
WHEN USING CAC AUTHENTICATION".
To logout...
When you have finished using the machine and are ready to log out, tap [Logout].
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
188 of 1441 3/17/2016 7:14 AM
To Next Page
Loading...
