Next click [User Control], [Default Settings] in the Web page menu.
Set the "Device Account Mode Setting".
Set the "User Authentication" drop down box to "Enable".
Check [Authenticate a User Common Access Card (CAC)].
Check the "Device Account Mode" and "Allow login by Default User".
Select the [User Selection] button.
Select the CAC user ("Site Guest") selected in step 4.
A pop up window will be displayed. Select [confirmation],then select [OK].
Click the [Submit] button.
Including the user name in the file name
The user name registered in the CAC card can be added to the scanned file name.
To configure this setting, select [Application Settings] → [Network Scanner Settings] →
[Administration Settings] in the Web page menu, and select "File Naming" on the
[Administration Settings] page. (Administrator rights are required)
When "Sender Name" is enabled in "File Naming", the user name of the CAC card is set in
"Sender Name" automatically. (All user name characters before the @ from user e-mail
address).
"E-mail to Self only" and "Allow Site E-mail Address"
Specify whether "Scan to Self" and "Scan to Site" are enabled.
To configure these settings, select [System Settings] → [Image Send Settings] → [Scan
settings] → [E-mail Setting] in the Web page menu (Administrator rights are required).
Enter an E-mail address for "Scan to Site" (maximum of 64 characters). If LDAP is set,
click the [Global Address Search] button to select the proper address.
You can easily set up the User Registration and Authority Group Registration in the Device
Access Mode setting by importing the Sample User Registration File ("Sample.bin" file). See
your Instruction Guide for details.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
192 of 1441 3/17/2016 7:14 AM
To Next Page
Loading...
