SELECTING THE PAPER TRAY FOR COPYING
Overview
The machine is set to automatically select a tray that has the same size of paper as the
size of the placed original (automatic paper tray selection).
If the original size cannot be detected correctly because it is a non-standard size or
when you want to change the paper size for copying, you can select the paper tray
manually.
Operation
Tap the [Paper Select] key, and tap the required tray key.
If the selected tray runs out of paper during a copy job and there is another tray that has
the same size and type of paper, that tray will be automatically selected and the copy job
will continue.
To change the initially selected tray:
In "Setting mode", select [System Settings] → [Copy Settings] → [Initial Status Settings]
→ [Paper Tray].
When selecting the bypass tray:
Specify the paper type and size based on the paper loaded into the bypass tray.
SPECIFYING A TYPE AND SIZE OF PAPER LOADED ON BYPASS TRAY
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
215 of 1441 3/17/2016 7:14 AM
To Next Page
