1-sided copy
Makes a 1-sided copy of the third original
page on an insertion sheet.
* The fourth original page is not
copied.
2-SIDED COPY
Makes a 2-sided copy of the third and four
th original pages on an insertion sheet.
Operation
Place the original in the document feeder tray of the automatic document
Before using the covers/inserts function, load insertion sheets in the tray.
When selecting the covers/inserts function, place the originals in the document
feeder tray, select 1-sided or 2-sided copying, and select the number of copies
and any other desired copy settings. When these settings have been completed,
perform the procedure to select covers/inserts.
The insertion sheet size must be the same as the copy size.
Up to 100 insertion sheets can be inserted.
The document glass is not available for this function.
Note that two insertion sheets cannot be inserted into the same page.
When performing 2-sided copying of 2-sided originals, an insertion sheet cannot
be inserted between the front and reverse sides of an original.
This function cannot be used in combination with the saddle stitch function.
This setting is not available when the covers/inserts function is disabled in
"Setting mode".
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
364 of 1441 3/17/2016 7:14 AM
To Next Page
