WHEN A COMMUNICATION ERROR OCCURS
If a communication error occurs or the other fax machine does not answer the call within a
preset period of time, transmission will automatically be attempted again after a preset
interval This function only operates in memory transmission mode.
In direct transmission mode, transmission will not automatically be attempted again
To cancel the transmission:
Cancel it from the job status screen.
STOPPING/DELETING A JOB IN PROGRESS OR RESERVED
To set the number of recall attempts and the interval between attempts when a transmission
fails due to an error:
In "Setting mode", select [System Settings] → [Image Send Settings] → [Fax Settings] →
[Send Settings] → [Recall in Case of Communication Error].
The factory default setting is one attempt at 3-minute intervals.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
557 of 1441 3/17/2016 7:14 AM
To Next Page
