FAX DEST. CONFIRMATION MODE
This mode displays a destination confirmation message when a fax is sent to prevent
accidental transmission to the wrong destination. Set it in setting mode. If a fax is sent
while this function is enabled, an address confirmation message will appear when the
[Start] key is tapped.
The message that appears will vary depending on the method used to specify the
destination.
Destination specified by one-touch key/search number
Tap the [Start] key to display all destinations in the destination confirmation screen.
Check that the destinations are correct, and tap the [Send Confirmation] key to start
scanning of the original.
If the destination is not correct, tap the [Cancel] key and select the destination again.
Destination specified using the numeric keys, [Select among addresses
After tapping the [Speaker] key while "Fax Dest. Confirmation Mode" is enabled, the
destination cannot be specified using the numeric keys, one-touch key, [Call Search
Number] key, or [Select among addresses recently sent to] key. However, it is possible to
send through a telephone.
To display the destination confirmation message prior to fax transmission:
In "Setting mode", select [System Settings] → [Image Send Settings] → [Fax
Settings] → [Default Settings] → [Fax Dest. Confirmation Mode].
To disable fax broadcast when Fax Dest. Confirmation Mode is enabled:
In "Setting mode", select [System Settings] → [Image Send Settings] → [Fax
Settings] → [Send Settings] → [Disable Fax Broadcasting].
You can select multiple one-touch keys for contacts or groups including fax
destinations.
Before tapping the [Send Confirmation] key, you can change scan or other settings.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
558 of 1441 3/17/2016 7:14 AM
To Next Page
