Tap the [Start] key to start scanning of the original.
If you inserted the original pages in the document feeder tray, all pages are
scanned.
A beep will sound to indicate that scanning and transmission have ended.
If you placed the original on the document glass, scan each page one at a
time.
When scanning finishes, place the next original and tap the [Start] key.
Repeat the procedure until all pages have been scanned and then tap the
[Read-End] key.
A beep will sound to indicate that scanning and transmission have ended.
Tap the [Preview] key to preview the output image before sending it. After you
have scanned an original by tapping the [Preview] key, tap the [Additional Scan]
key to scan the next original. Tap the [Start] key to start sending an image.
For more information, see "CHECKING THE IMAGE TO BE TRANSMITTED".
If you tap the [Function Rev.] key on the scan confirmation screen, you can
change the exposure, resolution, scan size, and send size.
(However, when scanning each even-numbered page of the original, only the
exposure can be changed.)
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
624 of 1441 3/17/2016 7:14 AM
To Next Page
