Place the next set of originals and tap the [Additionally Scan] key.
Tap the [Start Sending] key.
Tap the [Preview] key to check the preview of an image before sending a fax. For more
information, see "CHECKING THE IMAGE TO BE TRANSMITTED".
Set the [Change Setting of Following Original] checkbox on the action panel to before
tapping [Additional Scan] key as required, and then change the scan or send settings of
the next original.
To cancel scanning the original:
Tap the [Cancel Scan] key.
If no action is taken for one minute after the confirmation screen appears,
scanning automatically ends and the transmission is reserved.
The [Change Setting] key can be tapped to change the exposure, resolution, scan
size, and send size for each original page scanned. However, when Job Build is
used in combination with "Multi Shot" in "Others", only the exposure can be
changed when scanning each even-numbered page of the original pages.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
631 of 1441 3/17/2016 7:14 AM
To Next Page
