BOOK
USING A TRANSMISSION LOG TO RESEND
SENDING BY CHAIN DIALING
Tap the [Others] key, and tap the [Erase] key.
Tap the checkbox of the edge that you wish to erase, and specify the erase
position.
Check that he tapped checkbox is set to . If the [Specify Frame] key is
tapped, the [Up], [Down], [Left], and [Right] checkboxes are set to . If the
[Specify Frame+Center] key is tapped, all the checkboxes are set to .
Specify the erase width.
Specify the erase edge on the reverse side when erasing edges of one to three sides of Up, Down, Left,
and Right on the front side to scan a 2-sided original.
If the [Reverse erase position of back face.] checkbox is set to , the edge in the position
opposite to the erased edge on the front side will be erased.
If the [Reverse erase position of back face.] checkbox is set to , the edge in the same
position as on the front side will be erased.
Tap the numeric value display indicating the margin shift area on the front side or
reverse side, and enter the area using the numeric keys.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
642 of 1441 3/17/2016 7:14 AM
To Next Page
