Tap the [Start] key.
Scanning of the original starts.
If you inserted the original pages in the document feeder tray, all pages are
scanned.
A beep will sound to indicate that scanning and transmission have ended.
If you placed the original on the document glass, scan each page one at a
time.
When scanning finishes, place the next original and tap the [Start] key.
Repeat until all pages have been scanned and then tap the [Read-End] key.
A beep will sound to indicate that transmission has ended.
If the sub-address and passcode are already registered, you can select a
one-touch key as well.
If the passcode is omitted for the memory box of destination machine, you
can skip Steps (4) and (5).
Tap the [Preview] key to preview the output image before sending it. After you have
scanned an original by tapping the [Preview] key, tap the [Additional Scan] key to scan the
next original. Tap the [Start] key to start sending an image.
For more information, see "CHECKING THE IMAGE TO BE TRANSMITTED".
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
681 of 1441 3/17/2016 7:14 AM
To Next Page
