CHECKING FAXES RECEIVED BY F-CODE
CONFIDENTIAL RECEPTION
Overview
When an F-code confidential fax received, the fax is stored in the memory box specified
by the F-code. To check received faxes, enter the print passcode.
Operation
The machine rings and the fax is received.
A beep sounds when reception ends.
Tap the [Others] key, and tap the [Memory Box] key.
From the [Confidential] tab, tap the [Check received data list] key on the
Confidential faxes are automatically given priority in the print job queue.
The fax is automatically cleared from the memory box after being printed.
To perform this operation, the user must have [Access to Fax Data] permission.
To print transaction report automatically when an F-code confidential fax is received:
In "Setting mode", select [System Settings] → [Image Send Settings] → [Fax Settings]
→ [Default Settings] → [Transaction Report Print Select Setting] → [Confidential
Reception].
If you forget the print passcode:
There is no way to use the machine to check a print passcode that has been specified.
Exercise care not to forget the passcode. Should you forget or need to verify the
passcode, contact your dealer or nearest SHARP Service Department.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
682 of 1441 3/17/2016 7:14 AM
To Next Page
