INFORMATION APPEARING IN THE RESULT
COLUMN
Error types and other information are printed in the result column of transaction and
activity reports. When a transaction or activity report is printed, check the result of the
transaction in the result column and take action as needed.
Examples of messages that are printed in the result column
Message Description
OK The transaction was completed normally.
G3 Communication took place in G3 mode.
ECM Communication took place in G3 ECM mode.
SG3 Communication took place in Super G3 mode.
Forwarding The received data was forwarded.
NO RESPONSE No response from the receiving party.
BUSY Transmission was not possible because the other party was already using the
line.
CANCEL The transmission was canceled while in progress.
MEMORY OVER The memory became full during quick on-line transmission.
MEM. FULL The memory became full during reception.
LENGTH OVER The transmitted fax was over 59" (1.5 m) long and therefore could not be rec
eived.
ORIGINAL ERROR Direct transmission or manual transmission was not successful because a mis
feed occurred.
PASS# NG The connection was broken because the polling passcode was not correct.
NO RX POLL The machine that was polled does not have a polling function.
RX POLL FAIL The other machine refused the polling operation, or your machine broke the c
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
706 of 1441 3/17/2016 7:14 AM
To Next Page
