Operation
Place the original.
Place the original in the document feeder tray of the automatic document feeder,
or on the document glass.
AUTOMATIC DOCUMENT FEEDER
DOCUMENT GLASS
Specify the destination.
RETRIEVING A DESTINATION FROM AN ADDRESS BOOK
VIEWING A LIST OF THE SELECTED DESTINATIONS
USING A SEARCH NUMBER TO RETRIEVE A DESTINATION
ENTERING AN ADDRESS MANUALLY
If a ratio setting is used in combination with an erase setting, the erase width will change
according to the selected ratio.
This function erases the parts of the image where shadows tend to form, but does not
detect shadows and erase only the shadows.
For example, if you set an erase width of 1/2" (10 mm) and reduce the image to 70%
before scanning it, the erase width will be reduced to 7 mm.
To change the default erase width setting:
In "Setting mode", select [System Settings] → [Image Send Settings] → [Operation
Settings] → [Default Settings] → [Erase Width Adjustment].
The width can be set from 0" to 1" (0 mm to 20 mm). The factory default setting is 1/2"
(10 mm). The setting changed here will apply to [System Settings] → [Copy Settings] →
[Copy Setting] → [Erase Width Adjustment] in "Setting mode".
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
818 of 1441 3/17/2016 7:14 AM