Sharp MX-M502N

7-37
SYSTEM SETTINGS
Contents
Printer Settings
Image Send Settings
Item Factory default setting Page
■ Printer Settings
7-75
● Default Settings 7-75
X Prohibit Notice Page Printing Enabled 7-75
X Prohibit Test Page Printing Disabled 7-75
X A4/Letter Size Auto Change Varies depending on country and region 7-75
X Print Density Level 3 7-75
X Bypass Tray Settings 7-75
 Enable Detected Paper Size in Bypass Tray Disabled 7-75
 Enable Selected Paper Type in Bypass Tray Enabled 7-75
 Exclude Bypass-Tray from Auto Paper Select Disabled 7-75
X Job Spool Queuing Enabled 7-75
X Disabling of USB Memory Direct Print Disabled 7-75
X Disabling of Network Folder Direct Print Disabled 7-75
● Interface Settings 7-76
X Hexadecimal Dump Mode Disabled 7-76
X I/O Timeout 60 sec. 7-76
X Enable USB Port Enabled 7-76
X USB Port Emulation Switching Auto 7-76
X Enable Network Port Enabled 7-76
X Network Port Emulation Switching Auto 7-76
X Port Switching Method Switch at End of Job 7-76
Item Factory default setting Page
■ Image Send Settings
7-77
● Operation Settings 7-77
X Other Settings 7-77
 Default Display Settings Scan (fax when fax is installed)
7-77
• Hold settings for a while after scanning has been
completed
Disabled
 Address Book Default Selection Tab Switch: ABC, Address Type: All 7-77