UNPACKING & LOCK REMOVAL
Use Skid Slopes [UKOG-0367FCZZ] to remove device from shipping pallet.
Adjuster Cover installation.
DEVELOPER SET-UP
Sim 25-02 Auto Developer Adjustment - Select K (Only 1 Bag Required)
Toner Installation must be performed after Auto Developer Adjustment is completed.
**For optimum image quality & performance, it is recommended to setup & install
developer at the customer site.
TONER INSTALLATION & REPLENISHMENT
Install K Toner Cartridge.
PRODUCT ACTIVATION & FIRMWARE UPGRADE
Activation of Optional Product(s):- System Settings – Product Key.
Sim 22-05 Check Firmware version(s):- Upgrade to latest version.
Check MX-EBX3 option - ACRE firmware version must be 03.00.J2 (or higher).
INITIAL SETUP
Sim 26-02 LCC Installation (Paper Size).
Sim 26-06 Machine Destination.
Sim 26-35 Set Multi Error Counter:- Set to 1 (Multi Count).
Sim 26-52 Non Printed Paper Counter Set-up.
Sim 55-03 Process Mixed Size Pages (orientation) when Printing in Duplex:-
SSW 3-6, 0 = Disable, 1 = Enable.
Sim 55-03 Toner Remaining Display: SSW 22-5, 0 = Disable, 1 = Enable.
System Settings: Adjust Date/Time (Inc. Daylight Saving setting).
Keyboard Language Setting (For Embedded & Optional Keyboards):-
System Settings – Default Settings – Keyboard Select: Set English(US)
Set cassette size by adjusting the guides in the cassette.
Paper Size & Type Setting:- System Settings – Paper Tray Settings.
Sim 40-12 Multi Purpose Tray Adjustment/Calibration.
Set Active USB Port (MFP PWB DIP): SW2 OFF (Front - Default), ON (Rear)
Note: Both USB Ports are active when MX-KBX2 is installed.
To Next Page
Loading...
