19
General Problems
A COVER OR INSERT IS NOT PRINTED ON THE
SPECIFIED PAPER
Check Solution
Has the paper type been set
correctly?
■ Set the correct paper type for the tray that contains the paper specified for the
cover or insert.
If the paper type set for the cover or insert is not the same as the paper type set
for the tray, paper will be fed from a different tray.
⇒
"Settings" → [System Settings] → [Common Settings] → [Paper Settings] →
[Paper Tray Settings] → [Tray Registration]
THE CONNECTED USB DEVICE CANNOT BE USED
Check Solution
Is the USB device compatible with the
machine?
■ Ask your dealer if the device is compatible with the machine.
USB devices that are not compatible with the machine cannot be used.
Is the connected USB device
recognized correctly?
■ When a USB device is connected to the machine and correctly recognized, an
icon ( ) will appear at the top of the touch panel. If it is not recognized, connect
it once again.
Is the format of the USB memory
device FAT32?
■ Check the file format of the USB memory device.
If the format of the USB memory device is other than FAT32, use your PC to
change the format to FAT32.
Are you using a USB memory device
with a capacity of more than 32 GB?
■ Use a 32 GB or less USB memory device.
THE FINISHER/SADDLE FINISHER DOES NOT
OPERATE
Check Solution
Does a message appear indicating
that you need to remove paper from
the stapler compiler?
■ Remove all remaining paper from the stapler compiler.
Have functions been disabled by the
administrator?
■ Check with your administrator.
Some functions may have been disabled in the setting mode.
To Next Page
Loading...
Need help?
General
