Sharp MZ-80B - D Command

1.2.2 D command
Function
Operation
7
Dumps the specified memory block.
When
aD command is entered, the display screen is as shown in FIGURE 1.9.
FIGURE 1.9
At this time, the monitor program requests the operator to enter the first address
of the memory block. For example, to dump the memory block from $0000
through $007F (where part of the monitor program is stored) enter "0000" from
the keyboard as the start address (S-ADR), then press the [ CR J key. The dis-
play will
then be as shown in FIGURE 1.1 0.
FIGURE 1.10