Sharp PC7000A - Page 45

(a-6) Termination
PC-7000A
PC-7l00
Depression of the [ESC) key causes the control to return to the DSK test
menu (Fig.DSK-l).
Depression of the [F2) key interrupts the test with the following message on
display.
"Test stopped by user."
If the [Fl) key is pressed while the above message is on, the test resumes.
If the [ESC) key is pressed, the control returns to the DSK test menu
(Fig.DSK-l).
(b) Error processing
(b-l) Read/write related error
If an error occurred before the seek operation after the test started, the
test will be terminated irrespective of (a-4) "Error stop choice".
Depression of the [ESC) key causes the control to return to the DSK test
menu (Fig.DSK-l).
When an error was met during the read/write test, the command parameter and
the status of the error are displayed (Fig.DSK-ll) and the error count
displayed to the right is then incremented. If the error stop choice is
"No", the test continues after revising the display every time an error
occurred. (In this case, only the currently encountered error is displayed.)
If the error stop choice is "Yes", the test is interrupted immediately upon
occurrence of an error. In this case, the test can be resumed with the
depression of the [CR) key. If the [ESC) key is pressed, the control then
returns to the DSK test menu (Fig.DSK-l).
If printer is connected, command parameter of the error will be printed.
See the error message list which is attached to this text.
(b-2) Compare related error
When an unmatch is encountered in verifying the test data, the location and
the unmatch data are displayed.
Compare error
Adrs [Ox) = ~~~~
Da ta [07'1 = 6DEB
If the error stop choice is "No", the test continues after revising the
display every time an error occurred. (In this case, only the currently
encountered error is displayed.)
The error count is revised every time an error is met, whose count is in
terms of two bytes.
-43-