Sharp Plasmacluster DW-J27FV - Mold Control Operation; Timer Operation

EN-8
OPERATION
TIMER OPERATION
The Main Unit automatically starts once the
selected time passes.
The Main Unit automatically stops once the
selected time comes.
ON TIMER
OFF TIMER
(with the Main Unit OFF)
(with the Main Unit ON)
Front Display
Front Display
……
♪ ♪ ♪ ♪ ♪♪
1hour 2hour 3hour 12hour Cancel
……
♪ ♪ ♪ ♪ ♪♪
1hour 2hour 3hour 12hour Cancel
MOLD CONTROL OPERATION
【
for about 80 minutes
】
(Cleanliness Monitor: blinking with Purple)
※
Operating time depends on the room environment,
usage conditions, and location of the Main Unit.
NOTE
• When the air in the room is puried and the humidity
becomes low, the main unit operates with “Low” air
ow. ( Cleanliness Monitor : lighting in Blue)
• If the humidity becomes high again, it will switch to
the above operation under the condition of “in a high
humidity”.
In low humidity
In high humidity
It operates in “HIGH” mode of dehumidication
until the humidity of the room decreases to
the level in which the mold is less likely to
appears.
Once the humidity in room becomes low, the
model switches the operation with maximum
airow.
This mode is used to suppress the mold through
strong air ow with Plasmacluster Ion.
When turned ON, it rstly starts ventilation for 10
minutes with maximum air ow, and then repeats
following operation.
(Cleanliness monitor shows actual operating mode.
Purple: high air volume, Blue: low air volume.)
It operates automatically the Plasmacluster Ion
“ON”.
After 8 seconds, the beep sounds.
After 8 seconds, the beep sounds.