Sharp Plasmacluster DW-J27FV - How to Drain

EN-11
ENGLISH
1.
Remove the Plug.
2.
Remove the Water Tank and the
Rubber Cap.
Rubber Cap
3.
Set the hose in the Back Hole.
Back Hole
Commercial hose :
inner diameter 15mm
(outer diameter up to
21mm)
4.
Insert the hose rmly to bottom in the
Drain Hole.
HoseDrain OutletDrain Stopper
Back Hole
5.
Install the Water Tank.
When you want to drain continuous
HOW TO DRAIN
How to pipe the hose
♪♪･･･
When the Water Tank
is Full, the TANK FULL
Indicator Light is blinking.
Always have the tip slanted.
Do not bend.
Under cold weather,
do not put the hose
into the water.
1.
Remove the Water Tank.
Tank knob
Water Tank
2.
Dispose the water of the Water Tank.
▶
Drain Outlet
3.
Install the Water Tank.
Drain Outlet
NOTE
• Clean the Water Tank once a week. If you do not
clean the Water Tank, it can cause mold, bacteria,
and bad odors.