Sharp PN-80TC3 Service Manual

PN-L803C_80TC3 FIRMWARE UPDATE PROCEDURES 5 - 20
9) Release B1 after checking that the progress bar begins to increase.
10) After a progress bar reaches to 100%, check that LED of touch pen goes out, then click [Cancel].
(When [OK] is clicked by mistake, the process changes to state of writing firmware again. In that case, click [Cancel] to return.)
Release B1 after beginning to increase from 0%.
Check that LED of touch pen goes out.

Sharp PN-80TC3 Specifications

General

Brand	Sharp
Model	PN-80TC3
Category	Monitor
Language	English