Sharp PN-86HC1 - Supplied Components; Preparing the Remote Control Unit

5
E
ENGLISH
Supplied Components
Preparing the Remote Control Unit
1. Place your finger on the part marked with the ▲, and
then pull the cover off.
2. See the instructions in the compartment and put in the
batteries (R03 or LR03 (“AAA” size) x 2) with their plus
(+) and minus (-) sides oriented correctly.
3. Close the cover.
If any component should be missing, please contact your dealer.

Liquid Crystal Display Monitor: 1

Remote control unit: 1

Cable clamp (affixing type): 3

Power cord

Remote control unit battery: 2

CD-ROM (Utility Disk for Windows): 1

Setup Manual (this manual): 1

Touch pen: 2

Tray: 1

Tray mounting screws (M3x15): 5

USB cable: 1

Cover SHARP logo: 1
Place this sticker onto the SHARP logo to cover the logo.

Wireless Adapter: 1
* SHARP Corporation holds authorship rights to the Utility Disk program. Do not reproduce it without permission.
* For environmental protection!
Do not dispose of batteries in household waste. Follow the disposal instructions for your area.