Sharp PN-E601 - Binding Cables; Connecting the Power Cord; Removing the Handles

10
E
Connecting the Power Cord
Caution
• Donotuseapowercordotherthantheonesuppliedwith
the monitor.
1. Turn off the main power switch.
2. Plug the power cord (supplied) into the AC input terminal.
3. Plug the power cord (supplied) into the AC power outlet.
Binding Cables
The cables connected to the terminals on the rear of the
monitor can be fastened with the supplied cable clamp.
Insert the cable clamp into the cable clamp attachment on the
rear of the monitor and fasten the cables.
AC input terminal
1
Main power switch
Power cord (Supplied)
For power
outlet
2
3
Removing the Handles
The handles can be removed.
The removed handles can be attached on the rear side.
Caution
• Theremovedhandlesandhandlescrewsareforusewith
this monitor. Do not use them for any other devices.
• Toattachhandles,besuretousethehandlesandhandle
screws which were removed from the monitor.
• Besurethehandlesareattachedsecurely.
Handle
Handle screws
Handle
Handle screws
Cable clamp
Cable clamp
attachment
Cable