Sharp PN-L602B - Battery Safety Precautions; EMC Compliance and Radio Interference; Child Safety Measures

Installation
5
Mounting PN-TPC2W7A on Sharp PN-L Series
Displays
1. Before mounting, make sure to turn off the monitor
and remove the AC power.
2. Items needed
 Sharp PN-L Series Touch-
Screen Display
 PN-TPC2W7A
 Mounting Plate
 AC Power Adapter
 4 x M4 (0.7x10mm) screws
 2 x M3 (0.5x5 mm)
 Phillips
®
Screw Driver
3. Attach the mounting plate
There are 8 holes on the
mounting plate, but only use 4
holes to match the monitor’s
mounting holes depending on the
monitor model.
The mounting plate is attached to
the Sharp “PN-L” series display as
in Figure 2.
Secure the mounting plate to the
monitor with four included M4 screws.
*NOTE- Do not use the holes marked with the red x
Figure 1
Figure 2