Sharp PN-L602B

Installation
6
4. Set the AC power adapter in
place
Place the AC power adapter into
the holder on the right side of
the mounting plate as in Figure
3.
AC power cord faces downward
and the DC power cord to the
PN-TPC2W7A faces upward.
5. Install the PN-TPC2W7A
If you look at the right side of the
PN-TPC2W7A before sliding it into
the mounting plate as in Figure 4,
there are two small slits near the
edges on the PN-TPC2W7A and
two small fingers on either side of
AC power adapter holder on the
mounting plate.
As you slide the PN-TPC2W7A
into the mounting plate, insert
the two fingers into these slits as
in Figure 5.
Figure 4
Figure 3
Figure 5