Sharp PN-M401 - Preparing the Remote Control Unit; Installing the Batteries; Remote Control Operation Range

15
E
Installing the batteries
1. Place your nger on the part marked with the ▲, and then pull the cover off.
2. See the instructions in the compartment and put in the supplied batteries (R03 (“AAA” size) x 2) with their plus (+)
and minus (-) sides oriented correctly.
3. Close the cover.
TIPS
• Whenthebatteriesbecomeexhausted,replacethemwithnew(commerciallyavailable)batteries.
• Thesuppliedbatteriesmaybecomeexhaustedquicklydependingonhowtheyarestored.
• Ifyouwillnotbeusingtheremotecontrolforalongtime,removethebatteries.
• Usemanganeseoralkalinebatteriesonly.
Remote control operation range
Remote control sensor in
Theremotecontrolcanbeoperatedevenwhentheremotecontrolsensorisstoredinsidethemonitor.
Pointtheremotecontrolunittowardtheremotecontrolsensoronthebottomofthemonitor(ortherightsideofthemonitorif
usingportraitorientation).
For the monitor in landscape orientation For the monitor in portrait orientation
9.8 feet (3m)
9.8 feet
(3m)
9.8 feet
(3m)
Remote control
sensor
Remote control
sensor
20º
20º
10º
10º10º
10º
10º
10º
9.8 feet
(3m)
10 º
10 º
Preparing the Remote Control Unit