Sharp PN-R496

15
E
Preparing the Remote Control Unit
Installing the batteries
1. Place your nger on the part marked with the ▲, and then pull the cover off.
2. See the instructions in the compartment and put in the supplied batteries (R03 (“AAA” size) x 2) with their plus (+) and minus (-)
sides oriented correctly.
3. Close the cover.
TIPS
• When the batteries become exhausted, replace them with new (commercially available) batteries.
• The supplied batteries (R03 (“AAA” size) x 2) may become exhausted quickly depending on how they are stored.
• If you will not be using the remote control for a long time, remove the batteries.
• Use manganese or alkaline batteries only.
Remote control operation range
Remote control sensor in
The remote control can be operated even when the remote control sensor is stored inside the monitor.
Point the remote control toward the remote control sensor on the bottom of the monitor (or the right side of the monitor if using
portrait orientation).
For the monitor in landscape orientation For the monitor in portrait orientation
9.8 feet (3m)
Remote control
sensor
9.8 feet
(3m)
10º10º
9.8 feet
(3m)
Remote control
sensor
9.8 feet
(3m)
10º
10º
20º
10º
10º
20º
10º
10º
Remote control sensor out
Point the remote control toward the remote control sensor on the front of the monitor.
For the monitor in landscape orientation For the monitor in portrait orientation
30º
16.4 feet (5m)
10º
10º
10º
10º
Remote control
sensor
16.4 feet
(5m)
16.4 feet
(5m)
10º10º
10º
10º
Remote control
sensor
16.4 feet
(5m)
TIPS
• Do not expose the remote control unit to shock by dropping or stepping on it. This could lead to a malfunction.
• Do not expose the remote control unit to liquids, and do not place it in an area with high humidity.
• The remote control unit may not work properly if the remote control sensor is under direct sunlight or strong lighting.
• Objects between the remote control unit and the remote control sensor may prevent proper operation.
• Replace the batteries when they run low as this may shorten the remote control’s operation range.
• If a uorescent light is illuminated near the remote control unit, it may interfere with proper operation.
• Do not use it with the remote control of other equipment such as air conditioner, stereo components, etc.