27
E
n
MONITOR
PORTRAIT/LANDSCAPE INSTALL
LANDSCAPE ......Landscape orientation
PORTRAIT .........Portrait orientation
HORIZONTAL INSTALLATION
OFF ....................Portrait/landscape installation
UPWARD ............The display screen faces up.
DOWNWARD .....The display screen faces down.
ROTATE 180°
If video is upside down when the monitor is installed in portrait orientation, you can rotate the video 180 degrees.
Interlaced signals may not be displayed properly.
OSD H-POSITION
Adjusts the horizontal display position of menu screen.
OSD V-POSITION
Adjusts the vertical display position of menu screen.
POWER SAVE MODE
When OFF is selected, startup time from standby mode is reduced. Note, however that, more power will be consumed in
standby mode.
When ON is selected, current consumption is reduced while the monitor is in standby mode. Note, however, that the startup
time from standby mode becomes longer.
If set to ON, certain RS-232C commands cannot be used in standby mode, and control via LAN will be disabled. (See pages
34 and 46.)
OFF IF NO OPERATION
Determines whether or not to set the monitor to go into standby mode when there is no operation from the remote control unit,
RS-232C commands, or LAN.
When this is set to ON, use TIME to set the time until the monitor switches to standby mode.
POWER ON DELAY
When ON is set, you can delay the screen display after the monitor is turned on. When ON is selected, set the delay time with
INTERVAL (interval can be set up to 60 seconds in units of 1 second).
When this function is activated, the power LED ashes (at an interval of approximately 0.5 second) in green.
SELF ADJUST
On a D-SUB[RGB] screen, specify whether to perform screen adjustment automatically or not.
When ON is selected, the screen is automatically adjusted when its resolution is 800 x 600 or higher and the timing of input
signals changes. “ADJUSTING” appears on the screen during the adjustment.
If SELF ADJUST is set to ON, set the time it takes to start the SELF ADJUST function in START TIMING.
For images with black edges, etc., depending on the signal, adjustment may not be possible. In this case select OFF. (Perform
manual adjustment of the screen.)
Menu Items
To Next Page
Loading...
