Sharp PN-R903A

56
E
Specications
n
Product Specications
Model PN-R903A
LCD component 90" Class [90-1/16 inch (228.7cm) diagonal] TFT LCD
Max. resolution (pixels) 1920 x 1080
Max. colors Approx. 1.06 billion colors
Pixel pitch 1.038 mm (H) × 1.038 mm (V)
Max. brightness (typical) 700 cd/m
2
*
1
Contrast ratio (typical) 4000: 1
Viewing angle 176° right/left/up/down (contrast ratio ≥ 10)
Screen active area inch (mm) 78-7/16 x 44-1/8 (1993.0 x 1121.0)
Computer input signal Digital (DVI 1.0 standard-compliant), Analog RGB (0.7 Vp-p) [75
Ω
],
DisplayPort 1.1
Sync signal Horizontal/vertical separate (TTL: positive/negative), Sync-on-green*
2
,
Composite sync (TTL: positive/negative)*
2
Video color system NTSC (3.58MHz)/NTSC (4.43MHz)/PAL/PAL-60/SECAM
Plug and play VESA DDC2B
Power management VESA DPMS, DVI DMPM
Input terminals PC/AV HDMI x 2
Mini D-sub 15 pin, 3 rows x 1
PC DisplayPort x 1
DVI-I 29 pin (HDCP compatible) x 1
Audio 3.5 mm mini stereo jack x 2
Serial (RS-232C) D-sub 9 pin x 1
Output terminals PC DisplayPort x 1
DVI-D 24 pin (HDCP compatible) x 1
Audio 3.5 mm mini stereo jack x 1
Serial (RS-232C) D-sub 9 pin x 1
LAN terminal 10 BASE-T/100 BASE-TX
Speaker output 10 W + 10 W
Power requirement AC 100 V - 240 V, 7.5 A, 50/60 Hz
Operating temperature *
3
32°F to 104°F (0°C to 40°C)
Operating humidity 20% to 80% (no condensation)
Power consumption
(Maximum / input signal waiting mode *
4
/ standby
mode *
5
)
660 W / 1.4 W / 1.4 W
Dimensions (excluding protrusions) inch (mm) Approx. 80-7/8 (W) x 4-13/16 (D) x 47-1/8 (H) (2055 x 122 x 1197)
Weight lbs. (kg) Approx. 165.3 (75) (excluding the temporary stand used in the package
for transportation)
*1 Brightness will depend on input mode and other picture settings. Brightness level will decrease over time. Due to the nature of the
equipment, it is not possible to precisely maintain a constant level of brightness.
*2 D-Sub input terminal only.
*3 Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP. In such
cases, please check the temperature condition specied by the optional equipments.
*4 When AUTO INPUT CHANGE is set to OFF.
*5 When POWER SAVE MODE is set to OFF. When POWER SAVE MODE is set to ON: 0.5 W
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specication changes for product improvement
without prior notice. The performance specication gures indicated are nominal values of production units. There may be some deviations from
these values in individual units.