33
The wires in the mains cable are colour coded as shown
opposite:
As the colours of the cores in the mains lead of your oven
may not correspond with the coloured marking identifying
the terminals in your plug, connect the wires as shown:
Make sure the terminal screws are tight and the cable is
held securely by the cable grip where it enters the plug.
Like most appliances in your home, your oven must be con-
nected to a single phase 230-240 Volt, 50Hz alternating cur-
rent supply.
If you do not make the proper electrical connections you
might damage the oven or injure yourself. Neither SHARP
nor the supplier will be liable if this happens.
O REPLACE THE MAINS PLUG
T
green and yellow stripes = EARTH
blue = NEUTRAL
brown = LIVE
• The green and yellow wire to the plug terminal
marked E or
or coloured green or coloured green
and yellow.
• The blue wire to the plug terminal maked N or
coloured black or coloured blue.
• The brown wire to the plug terminal marked L or
coloured red or coloured brown.
!
WARNING:
THIS APPLIANCE MUST BE EARTHED.
IF YOU HAVE ANY DOUBTS ABOUT YOUR
ELECTRICAL SUPPLY ASK A QUALIFIED
ELECTRICIAN.
• If you are unable to resolve a problem using the checks
covered on the last few pages, do not attempt to serv-
ice this microwave oven yourself.
• Contact the dealer or supplier from whom the oven was
purchased in order to obtain service. Where this is not
possible, please contact the SHARP Customer Infor-
mation Center, telephone:
08705 274277 (office hours).
• For general information & assistance with oven que-
ries, please contact our
Customer Information Center:
U.K.: 08705 274277 (office hours)
Ireland: 01 676 0648 (office hours)
Website: http://www.sharp.co.uk/support
• Replacement accessories may be obtained from
our main parts distributor Willow Vale Electronics Ltd.
Telephone: 0121 766 5414
ALLING FOR SERVICE
C
R21AT,31-34 07.6.9, 10:37 AM33
To Next Page
Loading...
Need help?
General
