8
1. SEQUENCE COOKING
This function allows you to cook using up to 2 di erent stages which can include manual cooking times or time
defrost as well as a weight
defrost function. Once programmed there is no need to interfere
with the cooking
operation as the oven will automatically move onto the
next stage. An audible signal will sound once after the
rst stage. If the defrost function is needed within sequence cooking, please note
that this should always be
the rst stage of sequence cooking.
NOTE: AUTO MENU cannot be set as one of the multiple sequences.
Example: If you want to cook food for 20 minutes on P100 microwave power and then for 5 minutes with
P80 microwave power. The
steps are as follows:
1. Press the MICRO. POWER button, P100 will appear in the LED display.
2. Press the START/+30sec./ENTER button once to con rm the setting.
3. Enter the cooking time by rotating the ENTRY dial until the display shows “20:00” minutes.
4. Press the MICRO. POWER button, P100 will appear in the LED display.
5. Press the MICRO. POWER button twice or rotate the ENTRY dial to select the microwave power to P80.
6. Press the START/+30sec./ENTER button once more to con rm the setting.
7. Enter the cooking time by rotating the ENTRY dial until the display shows “5:00” minutes.
8. Press the START/ +30sec./ENTER button to start cooking.
Direct start
You can directly start cooking on P100 microwave power level for 30 seconds by pressing the START/ +30sec./ENTER
button. The cooking
process will start immediately and each time the button is pressed this will increase the
cooking time by 30 sec.
NOTE: The cooking time may be extended to a maximum of 95 minutes.
3. CHILD LOCK:
Use to prevent unsupervised operation of the oven by children.
a. To set the CHILD LOCK:
In the stand-by mode, press STOP/CLEAR button for 4 seconds. There will be a long beep denoting entering the
children-lock state and the
indicator will illuminate together with the current clock time. If the clock has
not been set the display status will be as follows:
w:llows:
b. To cancel the CHILD LOCK:
In the stand-by mode, press STOP/CLEAR button for 4 seconds. There will be a long "beep" denoting that the lock
is released.
2. +30sec FUNCTION / Direct tartS
OTHER CONVENIENT FUNCTIONS
To Next Page
Loading...
Need help?
General
