– 11 –
SD-AT1000
• Schematic diagram and Wiring Side of P.W.Board for this
model are subject to change for improvement without prior
notice.
• The indicated voltage in each section is the one measured
by Digital Multimeter between such a section and the chas-
sis with no signal given.
• Parts marked with “ 1 ” ( ) are important for
maintaining the safety of the set. Be sure to replace these
parts with specified ones for maintaining the safety and
performance of the set.
NOTES ON SCHEMATIC DIAGRAM
REF. NO
DESCRIPTION
POSITION
JOG701 JOG VOLUME ON—OFF
SW701 DIGITAL ON—OFF
SW702 LINE ON—OFF
SW703 TUNER (BAND) ON—OFF
SW704 TUNING UP ON—OFF
SW705 TUNING DOWN ON—OFF
SW706 POWER ON—OFF
TYPES OF TRANSISTOR AND LED
2SB709 AR
2SD601 AR
2SK208
CPH3418
KRA106 S
KRA107 S
KRC102 S
KRC104 S
KRC107 S
KTC2875 B
2SC5565
KTC4375 Y
AG01Z
AK09
DS1SS133
EK03
EK19
GD1N4004
B
(3)
E
(1)
C
(2)
BCE
TOP
VIEW
KDS120E
KDS121E
KDS226
TOP VIEW
TOP VIEWTOP VIEW
KTA1023 Y
KTA1266 GR
KTA1273 Y
KTC3199 GR
KTC3203 Y
VIEW
FRONT
E C B
VIEW
FRONT
123
(S)(G)(D)
(1)(2)(3)
SFPW56 MA111
D5SB60
AC AC
VIEW
FRONT
FRONT
VIEW
304AT2E
304BC2E9
304GT1U
304VT2E2
304VT2E3
SARS03
KRA102 M
KRC102 M
KRC104 M
KRC106 M
KRC107 M
VIEW
FRONT
Cathode Anode
FMLG22S
1. Anode
2. No Contact
3. Cathode
• Resistor:
To differentiate the units of resistors, such symbol as K and
M are used: the symbol K means 1000 ohm and the symbol
M means 1000 kohm and the resistor without any symbol is
ohm-type resistor. Besides, the one with “Fusible” is a fuse
type.
• Capacitor:
To indicate the unit of capacitor, a symbol P is used: this
symbol P means pico-farad and the unit of the capacitor
without such a symbol is microfarad. As to electrolytic
capacitor, the expression “capacitance/withstand voltage”
is used.
(CH), (TH), (RH), (UJ): Temperature compensation
(ML): Mylar type
(P.P.): Polypropylene type
To Next Page
Loading...
