Sharp SD-AT1000

E-17
SD-AT1000H_SEEG_E.fm03/3/14
SD-AT1000H
ENGLISH
TINSZ0943AWZZ
Basic Operation
- Listening to the radio -
Listening to the radio
! Manual or Auto tuning
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the "STEREO" indicator.
" " " will appear when an FM broadcast is in stereo.
" If the FM reception is weak, press the TUNER (BAND) button to extinguish the
"STEREO" indicator. The reception changes to monaural, and the sound becomes
clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to select the desired
frequency band.
3
Press the TUNING ( or ) button to tune in to the desired station.
Manual tuning:
Press the TUNING button as many times as required to tune in to the desired
station.
Auto tuning:
When the TUNING button is pressed for 0.5 seconds or more, scanning will start
automatically and the tuner will stop at the first receivable broadcast station.
" When radio interference occurs, auto scan tuning may stop automatically at
that point.
" Auto scan tuning will skip weak signal stations.
" To stop the auto tuning, press the TUNING button again.
" When an RDS (Radio Data System) station is tuned in, the frequency will be
displayed first, and then the RDS indicator will light. Finally, the station name
will appear.
" Full auto tuning can be achieved for RDS stations "ASPM", see page 27.
FM stereo receiving indicator
FM stereo mode indicator
FM stereo
FM monaural
AM