EasyManua.ls Logo

Sharp SD-AT1000H - Waveforms of 1-Bit Circuit

Sharp SD-AT1000H
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SD-AT1000H
– 42 –
WAVEFORMS OF 1-BIT CIRCUIT
T
2
1
2.00V/div
500 ns/div 194.545465 µs 520 mV
2.00V/div
AD IC Output
+ Side
- Side
5 V
Amplitude
from 0 to 5 V
1
2
T
10.0 V/div
500 ns/div 194.545465 µs -12.3 V
10.0 V/div
+ SIDE
+ FETOUT
- SIDE
Waveforms before low-pass filters at both
ends of the speaker.
H-bridge may be considered as BTL.
However, here and at the gate drive, dead
time is not observed; since bootstrap
operates based on output, DEAD TIME
part is in floating condition. The waveform
on the HIGH side shows that only the
booted voltage lowers.
2
1
11
12
2
1
2.00 V/div
500 ns/div 194.545465 µs -12.30 V
2.00 V/div
AD IC NF IN
In partial pressure OUT, 4 to 7 V amplitude
of GND reference is observed.
In IC of 75 kohms, the reference is 2.5 V
because of VREF. Due to imaginary GND
of operational amplifier inside IC, the
waveform cannot be monitored.
This waveform is partial pressure OUT.
3
4
T
2.00 V/div
50.0 ns/div 0.0 s -12.30 V
2.00 V/div
LEVEL SHIFT OUT
DEAD TIME
ZOOM UP
Dead time is generated by level
shift input.
Leading edge is delayed at CR,
passing R at DI.
Set value: 20 - 25 nsec.
5
6

Related product manuals