Regulatory information
Hereby, SHARP CORPORATION declares that the radio equipment type
SHV40 is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following
internet address:
(http://www.sharp.co.jp/k-tai/)
Manufacturer's Address:
SHARP CORPORATION,
1 Takumi-cho, Sakai-ku, Sakai-shi, Osaka 590-8522, Japan
•
•
Description•of•accessories
Headset, Handsfree φ3.5 audio jack, Bluetooth
USB cable For charging, peripherals, etc.
microSD memory card microSD/microSDHC/microSDXC
nano IC card au Nano IC Card 04/non-au Nano IC Cards
non-au Nano IC Cards can be used after
SIM-unlocking the handset.
•
•
Frequency•range•of•supported•bands•in•EU
GSM 900 Tx 880.2 to 914.8 MHz
Rx 925.2 to 959.8 MHz
DCS 1800 Tx 1710.2 to 1784.8 MHz
Rx 1805.2 to 1879.8 MHz
WCDMA FDD Ⅰ Tx 1922.4 to 1977.6 MHz
Rx 2112.4 to 2167.6 MHz
WCDMA FDD Ⅷ Tx 882.4 to 912.6 MHz
Rx 927.4 to 957.6 MHz
LTE Band 1 Tx 1922.5 to 1977.5 MHz
Rx 2112.5 to 2167.5 MHz
LTE Band 3 Tx 1710.7 to 1784.3 MHz
Rx 1805.7 to 1879.3 MHz
LTE Band 8 Tx 880.7 to 914.3 MHz
Rx 925.7 to 959.3 MHz
Bluetooth Tx 2402 to 2480 MHz
Rx 2402 to 2480 MHz
WLAN 2.4 GHz Tx/Rx 2412 to 2472 MHz (BW:20 MHz only)
NFC Tx/Rx 13.56 MHz
GNSS GPS: Rx L1 (1575.42 MHz)
GLONASS: Rx G1 (1598.0625 to 1605.375 MHz)
•
•
Maximum•transmit•power
GSM 900 +33 dBm (Power Class4)
DCS 1800 +30 dBm (Power Class1)
WCDMA FDD Ⅰ +24 dBm (Power Class3)
WCDMA FDD Ⅷ +24 dBm (Power Class3)
LTE Band 1 +23 dBm (Power Class3)
LTE Band 3 +23 dBm (Power Class3)
LTE Band 8 +23 dBm (Power Class3)
Bluetooth +7.3 dBm (Power Class1)
WLAN 2.4 GHz +14.0 dBm
NFC 0 dBμA/m at 10 m
■ Mobile Light
Do not point the illuminated light directly at someone's eyes.
Be especially careful not to shoot small children from a very close distance.
Do not use Mobile light near people's faces. Eyesight may be temporarily
affected leading to accidents.
■ AC Adapter
Any AC adapter used with this handset must be suitably approved with a 5Vdc
SELV output which meets limited power source requirements as specified in
EN/IEC 60950-1 clause 2.5.
26